Aussie Owned & Operated

Pre-Made Kits to suit every application

Our Service Difference


Victron MultiPlus 12/2000/80-32 – 2.0kW 12V Inverter/Charger

Original price was: $2,245.10.Current price is: $1,925.65. (inc. GST)

The MultiPlus is an Inverter and Charger combination supporting easy installation

  • True sine wave inverter
  • Adaptive charging
  • Hybrid PowerAssist
  • PowerControl
  • Multiple system integration

Multifunctional, with intelligent power management

The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology, and a high-speed AC transfer switch in a single compact enclosure. Next to these primary functions, the MultiPlus has several advanced features, as outlined below.

Parallel operation and three phase capability

Up to six Multis can operate in parallel to achieve higher power output. In addition to parallel connection, three units can be configured for three-phase output.

PowerControl - Dealing with limited generator, shore side or grid power

With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.

PowerAssist - Boosting the capacity of shore or generator power

This feature takes the principle of PowerControl to a further dimension. It allows the MultiPlus to supplement the capacity of the alternative source. Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.

Four stage adaptive charger and dual bank battery charging

The main output provides a powerful charge to the battery system by means of advanced ‘adaptive charge’ software. The software fine-tunes the three-stage automatic process to suit the condition of the battery, and adds a fourth stage for long periods of float charging. The adaptive charge process is described in more detail on the Phoenix Charger datasheet and on our website, under Technical Information. In addition to this, the MultiPlus will charge a second battery using an independent trickle charge output intended for a main engine or generator starter battery.

High start-up power

Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.

Search Mode

When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.

Programmable relay

By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).

Remote on / off / charger on

Three pole connector to mount an external remote if required.

Additional information

PowerControl / PowerAssist


Three Phase and parallel operation


Transfer switch


Input voltage range

9.5 – 17V


Output voltage: 230VAC ± 2% Frequency: 50Hz ± 0,1% (1)

Cont. output power at 25°C (3)


Cont. output power at 25°C


Cont. output power at 40°C


Cont. output power at 65°C


Peak power

3500 W

Maximum efficiency


Zero-load power


Zero-load power in search mode


AC Input

Input voltage range: 187-265 VAC Input frequency: 45 –65 Hz

Charge voltage 'absorption'



Output short circuit
Battery voltage too high
Battery voltage too low
Temperature too high
230VAC on inverter output
Input voltage ripple too high

Dimensions (h x w x d)

500 x 225 x 135 mm




M8 Bolts

230V AC-connection