Aussie Owned & Operated

Pre-Made Kits to suit every application

Our Service Difference

Sale!

Victron Cable for Smart BMS CL 12-100 to MultiPlus

Original price was: $34.00.Current price is: $30.91. (inc. GST)

The Victron Cable for Smart BMS CL 12-100 to MultiPlus is a specialized cable that allows the Victron Smart BMS CL 12-100 to communicate with the Victron MultiPlus inverter/charger. This cable is used to transmit data between the BMS and the inverter/charger, allowing the inverter/charger to monitor and control the charging of the battery.

SKU: ASS070200100 Categories: ,

Cable for Smart BMS CL 12/100 to MultiPlus:

This cable connects between a non VE.Bus BMS (Smart BMS CL 12-100 or miniBMS) and a MultiPlus (MultiPlus, MultiPlus Compact or MultiPlus-II). The cable will turn the MultiPlus off as soon as the BMS has detected a low voltage, high voltage or temperature alarm condition in the Victron lithium-iron-phosphate (LiFePO4) Smart Battery bank. Once the alarm condition has been cleared, the BMS will turn the MultiPlus back on. This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA – 2kVA and MultiPlus-II models to be used with BMS products that have no VE.Bus interface, such as the Smart BMS CL 12-100 and the miniBMS.

 
These MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs respectively. The cable must be wired to the remote on/off connector of the MultiPlus models:

- When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red wire to the (+) terminal.

- When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal.

- When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal.

Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger outputs of the miniBMS must be in ‘High’ state in order for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and start charging (if connected to an AC power source).