Aussie Owned & Operated

Pre-Made Kits to suit every application

Our Service Difference

Sale!

Victron BlueSolar PWM-Pro 12/24V-10A

$60.91 (inc. GST)

.

The Victron BlueSolar PWM-Pro 12/24V-10A is a charge controller designed for small-scale solar power systems. It can handle up to 10 amps of current and can be used with both 12 and 24 volt battery systems.

The PWM-Pro uses pulse width modulation (PWM) technology to regulate the charging of the batteries. This means that it will vary the amount of power sent to the batteries based on their state of charge. When the batteries are low, it will send more power to them, and when they are full, it will send less power.

 

SKU: SCC010010010 Categories: ,

Victron Bluesolar pro PWM solar controller:

Victron's range of  PWM and MPPT charge controllers are both widely used to charge batteries with solar power.

The PWM controller is in essence a switch that connects a solar array to the battery. The result is that the voltage of the array will be pulled down to near that of the battery.

A PWM controller is not a DC to DC transformer. The PWM controller is a switch which connects the solar panel to the battery. When the switch is closed, the panel and the battery will be at nearly the same voltage. Assuming a discharged battery the initial charge voltage will be around 13 V, and assuming a voltage loss of 0,5 V over the cabling plus controller, the panel will be at Vpwm = 13,5 V.

 

The voltage will slowly increase with increasing state of charge of the battery. When absorption voltage is reached the PWM controller will start to disconnect and reconnect the panel to prevent overcharge (hence the name: Pulse Width Modulated controller).

Programmable:

The BlueSolar PWM-Pro series is ready for use with its default settings. It also is fully programmable:

 

-With help of a computer and software (available free of charge from Victron website)

-With the dedicated BlueSolar Pro Remote Panel.

 

Features:

  • -Lighting control function, fully programmable.
  • -Three stage battery charging (bulk, absorption, float), fully programmable.
  • -Integrated battery monitor function (Remote Panel needed to display state of charge).
  • -Load output with low voltage disconnect and manual control (default setting).
  • -Optional external temperature sensor.
  • -Load output protected against over load and short circuit.
  • -Protected against reverse polarity connection of the solar array and/or battery.

Additional information

BlueSolar PWM-Light

12/24-10

Battery Voltage

12/24V with automatic system voltage detection

Rated charge current

10A

Automatic load disconnect

Yes

Maximum solar voltage

28V / 55V (1)

Self-consumption

< 10mA

Load output

Manual control + low voltage disconnect

Protection

Battery reverse polarity (fuse) Output shortcircuit Over temperature

Temperature compensation

-30 mV / °C resp. -60 mV / °C

(if temperature sensor installed)

Remote panel

Optional (article SCC900300000)

Grounding

Common positive

Operating temp. range

-20 to +50°C

Humidity (non-condensing)

Max 98%

Absorption charge (2)

14.4V / 28,8V

Float charge (2)

13.8V / 27,6V

Equalization charge (2)

14,6V / 29,2V

Low voltage load disconnect

11,1V / 22,2V

Low voltage load reconnect

12,6V / 25,2V

Terminal size

4mm²

Protection category

IP30

Weight

0,13kg

Dimensions (h x w x d)

138x70x37 mm

5.4×2.7×1.4 inch

Downloads

Datasheet-BlueSolar-PWM-Pro-Charge-Controllers-EN Victron BlueSolar PWM-Pro 12/24V-10A